- 5015 Form Factor
- 4500 RPM
- 3 pin connect with 750mm leads
- Perfect fit for Prusa MK3 blower fan
** please note this is a 3rd party fan and the fan sensor may not read correctly on the Prusa printer this fan will still work but you will need to disable the sensor in the menu."
- fan speed
- printing temp constant
- airflow noise
- stock part
- Prusa MK3s
Super satisfied with the the overall experience.
I saw in some forums these specific fans worked great for many 3D printers, unfortunately I burned one by mistake but it was my own fault. but overall this retailer provided all the information I needed, kept me promptly updated, and everything was well packed. Thanks to all the Printer Solid staff for such a great customer experience.
Unstable RPM readings caused a "Print Fan Error"
The dimensions of these fans are correct and they fit properly. Unfortunately, I found that the RPM readings are unstable at 100%. The fan does work when run for example at 80% but this is disappointing and RPM readings are still unstable (just not enough to cause a failure). I'm not sure if I just got a defective fan or if there is an issue with the RPM sensors that these fans use.
Too much, too slow
I received one from Prusa in Czech a day earlier, that was sent 2 days after., and the shipping cost was the same. I also later found on Amazon two for price of one with no shipping cost.
It was a direct replacement for the prusa mk3s print fan.
Blow baby blow
Great buy Installed it on my Prusa mini it works great great It a must have !
- Choosing a selection results in a full page refresh.