Prusa MK2 MK3 Thermistor Cartridge
Prusa MK2 MK3 Thermistor Cartridge
This is the standard E3D Thermistor Cartridge that has been customized for installation on the Prusa MK2 / MK3 by splicing in 750mm of cable.
A custom made thermistor encapsulated into an easy to use cartridge package.
Using our proven Semitec 104GT thermistors, which are then potted into a cylindrical copper cartridge with a high conductivity ceramic based adhesive. The legs are insulated with fibreglass sleeving, and terminated with a Molex Microfit 3.0 connector.
- Reviews
- Questions
- Prusa
- length
- thermistor
- wire
- issue
- part
- shipping
- board
- cartridge format
- clip
Just What I Needed!
Printer was giving a Thermal Anomaly error. Removal of original thermistor was difficult because I could not heat up the heat block with the error. Once the part was replaced, the MK3S+ printer worked beautifully again!
Did the trick
It was the correct length and fitment to get my prusa mk3s+ up and running again. Cheap enough that I ordered spares to have on hand.
Mk3s thermistor
I haven't used this yet. My unit is 4+ yrs.old and during a recent printing mishap I had to remove blobs of plastic from the heater block and noticed I could see the fine bare wire from the thermistor.(thought it was broken but it wasn't) So this is a spare. It looks well made and arrived quickly
Great USA resource for Prusa
When Prusa was out of stock, you had exactly what I needed shipped it immediately, and it got here long before Prusa ever had it in stock. What an excellent resource for 3-D printers.
- Choosing a selection results in a full page refresh.