PRUSA RESEARCH ACQUIRES PRINTED SOLID INC. TO BE THEIR EXCLUSIVE RESELLER AND SERVICE CENTER IN THE USA
E3D
E3D Revo™ Micro
E3D Revo™ Micro
Couldn't load pickup availability
Ready for Revo. Change nozzles at room temperature using just your fingers. No complex tools, no hot tightening. Revo Nozzles are a factory sealed nozzle and heatbreak in one, so they’re easy to fit and can’t leak material when in use.
New hotness. A Revo HeaterCore heats up in seconds. It’s much safer too – unlike other solutions on the market, a positive temperature coefficient (PTC) means the Revo HeaterCore can not melt at extreme temperatures: power reduces as it gets hotter, so hazards are reduced in the event of a thermal runaway.
Runs cool, looks cool. With an anodised black heatsink, not only does Revo Micro run cool – it looks cool, too.
Flexible to any setup. Revo Micro plays nice with Bowden and direct drive setups, but its lightweight construction makes it an ideal choice for Bowden setups.
Please note:
- This kit does not include any 3D printed mounts
- The Revo Micro fan must be connected using the 5V regulator unless connecting directly to a 5V pin
- Reviews
- Questions
- hotend
- nozzles
- firmware
- PETG
- instructions
- drop
- start
- trouble
- settings
United StatesBest upgrade for mini*
The instructions are clear, and the product just works. I like how it’s a drop In replacement so I didn’t have to mess with any firmware or settings. One thing I would recommend is editing the start and end gcode so that it retracts the filament enough at the end of a print that you can change the nozzle with out heating the nozzle back up again. And then the starting gcode will it extrude the same retract amount so that it loads and prints properly. Overall I wish I had just installed this when I first got my printer instead of the headache that I had changing nozzles with the old hotend. Also, check on Etsy for people who print custom STL and get the mount printed in PC-CF for extra stiffness and strength.
United StatesGood hotend (but issues with E3D mount)
Installed this on my Prusa Mini. E3D's first edition mount had heat creep issues. The Mini firmware undervolts the hotend fan, which couldn't keep up when printing PLA. I had no issues printing PETG or ABS. They subsequently released a second edition mount that uses the stock fan. Although this is louder, the heat creep went away. It's now working reliably on my Mini.
United States United StatesThe ONLY hotend!
I have been using E3D hotends for over 5 years, now. I run my own print farm where all of my printers are equipped with E3D V6's. When the Revo got announced, I was incredibly excited. When I got one to finally test out, I was blown away. All of the high quality you would expect from E3D in a more convenient package. Running a farm and being able to change nozzles without tools or heat tightening made it a no brainer for me. That convenience alone is worth every penny. I'm currently in the middle of converting the rest of my printers to the Revo. This is the ONLY hotend for me.
United StatesWorks great on Prusa Mini!
Used this to upgrade my Prusa Mini+ and couldn't be happier!
- Choosing a selection results in a full page refresh.