Sigi's Helicopter 3D Printed in Woodill Coarse

This is a fun model I downloaded from to print. It was printed in colorFabb woodfill coarse on an Ultimaker with a nozzle drilled out to 0.8mm.  0.2mm layer height.  I think all 4 parts took about 40 minutes. [gallery ids="2976,2975,2974"] Source for this file: Licensed CC-NC-SA

Matthew Gorton
Matthew Gorton


Matthew Gorton is the founder of He is a mechanical / materials engineer by education and has worked as a design, process and quality engineer in the medical, electronics, and aerospace industries. He is enthusiastic about applying all he has learned through these experiences to 3D printing and sharing that with others.

Leave a comment

Comments will be approved before showing up.