PRUSA RESEARCH ACQUIRES PRINTED SOLID INC. TO BE THEIR EXCLUSIVE RESELLER AND SERVICE CENTER IN THE USA
Printed Solid
Voron V0 and V0.1 and V0.2 Panel Set Made From Aluminum Composite Material
Voron V0 and V0.1 and V0.2 Panel Set Made From Aluminum Composite Material
Couldn't load pickup availability
Voron V0 / V).1 / V0.2 Panel Set Made From Aluminum Composite Material. All are CNC cut and give a smooth metal look to your printer. Available in White with Black core edge or Black with black core edge. Made with 1/8” inch (3.175mm) thick material.
Aluminum Composite Material is a nice smooth material with aluminum on both sides of a lightweight panel which gives excellent strength and great heat reflection in the build area compared to other materials used for panel sets.
The V0 kit contains the following:
Middle piece 230mm x 170mm
Deck Front piece 209mm x 172mm
Rear piece 212mm x 248mm
Deck Back piece 208mm x 41mm
The V0.1 kit contains the following:
Back piece 212mm x 248mm
Deck piece 209mm x 172mm
Rear piece 230mm x 170mm
Motor piece 122mm x 37mm
The V0.2 kit contains the following:
Upper Rear Panel 212mm x 63mm
Motor Panel 122mm x 37mm
Mid Panel 230mm x 170mm
Lower Rear Panel 212mm x 185mm
Deck Panel 209mm x 172mm
Bottom Panel 213mm x 213mm
- Reviews
- Questions
- printer
- panels
- frame kit
- Solid
- spacer
- materials
- Voron V0
- Nice
- extra"
- digit
Always awesome quality
I’ve bought multiple sets and they’re always terrific quality.
United States United StatesOkay...
I always get some bad cuts, but they don't affect anything but the looks. And you ARE buying these for the actual look. Otherwise you'd be satisfied with horrible plexi. The more I order, and the more defects that come with it, the less stars get added. I would not mind if the issue was fixed on your end, but if you cannot be bothered to fix your CNC ability, I'll just do it myself from this point going forward. Less and less I will buy made already from this place, and more and more I'll shop elsewhere.
United StatesAwesome Panels
Nice, sturdy, these will outlast the printer I'm sure. The back piece needs a spacer, but they don't tell you. The manual leaves that out as well. Only thing I can fault is the lack of documentation and the machine they used to cut these marred the same spot on each panel, it seems. There was an obvious "extra" cut on pieces like they overshot the line that was marked. I doubt these were cut by hand, but they sure don't look like care in machining was used. Doesn't detract from the fit and function on mine, but they could definitely cut a digit.
United StatesWhite panels fit a Voron 0.1 perfectly
These panels seem thick, but slid into a generic V0.1 frame kit well. The aluminum covering seems to take the heat well. However, there might be some variance in Makerbeam XL type extrusions depending on manufacturer, so results might vary.
- Choosing a selection results in a full page refresh.