VisionMiner Nano Polymer Adhesive
10ml bottle only TRY out Vision Miner Nano Polymer Adhesive.
Designed for PEEK, Ultem™, PPSU, and other high-performance FDM polymers, this build plate glue works for nearly every filament - Nylon, ABS, PLA, PETG, PEI, PSU, and every filament we've tested so far.
Not only that, but it works on multiple build surfaces as well:
Borosilicate glass, ceramic glass, PCB board, Carbon Fiber, Fiberglass, Aluminum, BuildTak™, PEI, and more.
Designed for PEEK, PEI, and high-temp materials
NO MESS like Glue Stick or Hair Spray - with Better Grip
Easy to clean and re-apply
Made from safe, non-toxic, organic compounds
THE LAST BUILD PLATE GLUE YOU'LL EVER NEED
WORKS WITH MOST MATERIALS
Created by World-Leading Polymer Scientists.
PATENT PENDING - OVER A YEAR IN DEVELOPMENT
Back in January of 2018, the journey began. We went straight to the top - adhesive-specialized material scientists. Very quickly, we created the perfect adhesive, keeping high-performance materials like solidly attached to the build plate -- no mess, no wasted time, just pure grip.
Here at Vision Miner, we know how tough printing high-temperature thermoplastics can be. There’s nothing worse than starting a print job just to find out that your base layer shifted and your printer has been extruding on open air for the past five hours.
That’s why we spent almost a YEAR consulting material scientists to formulate a new nano polymer adhesive -- light years ahead of what any glue stick can do.
Formulated in Costa Mesa, California, we're proud to finally announce the BEST build plate adhesive for high-temperature thermoplastics. Designed specifically for PEEK and PEI, this build plate glue is our solution for adhesion with extreme pulling forces.
Withstanding pull-force pressures over 20,000 PSI, this adhesive works on multiple surfaces -- borosilicate glass, carbon fiber, PEI, and more.
What's more -- it works on PPSU, PPS, PSU, Nylon, ABS, ASA, Polycarbonate, and even more filaments. For PLA and PETG, you can use the same coating 50+ times -- and each bottle has over 300 7"x7" coatings worth of adhesive.
INSTRUCTIONS FOR USE
>Clean Glass (use water, or alcohol)
>Apply Adhesive (spread evenly on Build Area)
>Print Your Part
When you're extruding below 300ºC, generally you can remove the part as soon as the plate cools. With materials like PLA or PETG, it usually pops itself off the plate. If it sticks too much, you can apply water around the base of the part, which will help it release. This occasionally happens with ABS.
When you're extruding over 300ºC, remove the part as quickly as possible. You want the buildplate and part to be HOT when you remove it -- high-temp materials contract extremely quickly when cooling, and parts can shatter glass in less than 30 seconds.
CAUTION when using ABS on Glass
ABS contracts very quickly when it cools; because of this, the risk of chipping, chunking, or breaking glass is higher with ABS. We recommend using Kapton Tape, PEI, or some other type of protective surface on top of glass when printing ABS. Because this happens with gluestick, hairspray, and other adhesives, we are not responsible for broken or chipped buildplates when using this product.
Ensure proper leveling. High-temp materials must be removed extremely quickly. High Performance Polymers cool faster than glass, which can cause chipping. Prevent this by removing parts quickly.
- Choosing a selection results in a full page refresh.