NinjaTek's third flexible filament. At a shore hardness of 95A, Cheetah has about the same flexibility as SemiFlex and is a bit stiffer than Ninja. It's a great choice where you need a lot of flex, but more structure than you get with NinjaFlex.
This filament can be printed without modification on many printers including Bowden feeds like the Ultimakers that have difficulty with regular NinjaFlex, but adding a reinforced extruder like the E3D Titan, Aero, will allow you to print at faster speeds.
Extruder Temperature: 230°C 240°C
Platform Temperature: Room temperature 45°C
Glue or blue painters tape is suggested if not using a heated bed.**If using PEI or BuildTak, glue over the surface is a must to prevent damage**
Top and bottom layers: 30-45 mm/ sec
Infill speeds: 60-80 mm/ sec
Layer 2+ use cooling fan if available.
Heat Deflection Temperature: 46°C>
- Choosing a selection results in a full page refresh.