colorFabb
colorFabb PA Neat 2.85mm X 700g
colorFabb PA Neat 2.85mm X 700g
Couldn't load pickup availability
From colorFabb:
PA Neat. A brand new unfilled, heat resistant, low warp PA
PA Neat is our new highly functional polyamide (nylon) grade. PA NEAT allows continued use at 120°C while retaining sufficient mechanical properties and thus highly temperature resistant and tough. This makes it a perfect material for the professional user to make durable prints that need to perform.
PA Neat barely warps and is thus ideally suited for professional users who need their filament to perform.
Due to high stiffness of 2.85mm filament we recommend users to use spoolmounts which have some friction between spool and holder, to prevent unspooling of filament.
The filament may absorb moisture from the environment. If absorbed moisture levels are too high, users will see excessive oozing of material on travelmoves and rough outer surface of printed parts. Drying is advised using filament dryers, drying temperature set at 70-80C for 4-6 hours.
Read more about print settings and advice on https://pa.colorfabb.com
Material:
Colorfabb PA Neat
Diameter Tolerance:
± 0.1 mm
Density:
1.4 g/cm3
Continuous Use Temperature:
120C
Advised 3d printing temperature:
265C-290C
Advised 3d print speed:
30 - 40 mm/s
Advised Heated bed (if you have one, not strictly necessary):
ambient - 50C
We recommend using glue stick for improved adhesion.
Cooling fan
0% fan cooling is advised to achieve best possible layer to layer adhesion. If a geometry needs cooling a maximum of 50% regular fan speed is advised.

- Choosing a selection results in a full page refresh.