- Black anodized aluminum to remove heat from desired component.
- Equipped with 3M self-adhesive on the back for easy attachment.
- Fits Well on Nema17 stepper motors.
- JST-XH4 4-pin connector to JST-XH6 6-pin connector.
- This cable is by default wired for our 40 mm Geared Nema17 motor, please make sure that it follows the schematics for your application.
- Controller side Motor side
- PIN 1 —————– PIN 1
- PIN 2 —————– PIN 4
- PIN 3 —————– PIN 3
- PIN 4 —————– PIN 6
High precision needle bearing that is used in our Bondtech drive gears, for shaft diameter 3.0 mm, two bearings is used for one drive gear.
- Hardened and precision ground shaft for the Bondtech gearkits.
- This mount for BMG extruder is CNC machined to precise tolerances in 3 mm thick aluminium that assures a secure and stable mounting for the extruder.
M3 Threaded insert
Thread insert for applications when a metal thread is needed with plastic parts.
To attach the thread in plastic, a hole is required in the correct size for the selected insert.
Insert the thread insert into plastic with heat. The easiest is to make a special tip for a soldering iron and use it to heat up and fit the insert into the plastic.
High precision ball bearing that is used in the BMG and in our Dual & Single direct extruders for Raise3D.
- Dimensions: 5.0×8.0x2.5
- Thumbscrew replacement for all bondtech extruders
- only hand tighten do not use tools
- M3 Thread Size
- Replacement Shaft assembly for our BMG, Single and Dualdirect extruders.
- Including setscrew for primary 1.75/5.0 drivgear.
- Color may vary
17 tooth gear in steel
M3x3 setscrew used in our BMG, Single and Dualdirect extruders.
Please make sure that the setscrew does not collide with the secondary plastic gear when assembled.
- Color may vary