Prusa MK2 MK3 Thermistor Cartridge
Prusa MK2 MK3 Thermistor Cartridge
This is the standard E3D Thermistor Cartridge that has been customized for installation on the Prusa MK2 / MK3 by splicing in 750mm of cable.
A custom made thermistor encapsulated into an easy to use cartridge package.
Using our proven Semitec 104GT thermistors, which are then potted into a cylindrical copper cartridge with a high conductivity ceramic based adhesive. The legs are insulated with fibreglass sleeving, and terminated with a Molex Microfit 3.0 connector.
- Reviews
- Questions
- Prusa
- length
- thermistor
- wire
- part
- issue
- shipping
- Item
- problem
- fitment
Failed after less than 20 hours of printing
Failed after less than 20 hours of printing. Printer has begun giving thermal anomaly errors on both Klipper and Prusa firmware.
Did the trick
It was the correct length and fitment to get my prusa mk3s+ up and running again. Cheap enough that I ordered spares to have on hand.
Mk3s thermistor
I haven't used this yet. My unit is 4+ yrs.old and during a recent printing mishap I had to remove blobs of plastic from the heater block and noticed I could see the fine bare wire from the thermistor.(thought it was broken but it wasn't) So this is a spare. It looks well made and arrived quickly
Great USA resource for Prusa
When Prusa was out of stock, you had exactly what I needed shipped it immediately, and it got here long before Prusa ever had it in stock. What an excellent resource for 3-D printers.
- Choosing a selection results in a full page refresh.